Course Details
Overview
This training event is three-days instructor led product training course to update the Cisco Catalyst 6500 training found in the DCNI-1 certification course. The purpose of this event is to prepare students to implement the CAT6500 series switches using the updated software with particular attention to the new Supervisor Engine 2T software.
Objectives
Upon completing this course, the learner will be able to meet these overall objectives:
Module 1 Objective:
- Catalyst 6500 Series Switches hardware and architecture of chassis and line cards, with Supervisor engine 2T
Module 2 Objective:
- Catalyst 6500 Series Switches core technologies with Virtual Switching System 1440
- Multicasting, Cisco TrustSec, Network Virtualization and Data Center Interconnect (Catalyst 6500 Series switches)
Module 3 Objectives:
- Catalyst 6500 Series Switches hardware implementation
Outline
Course Introduction
Module 1: Catalyst 6500 Series Switches Architecture
- Lesson 1: Assessing Catalyst 6500 Series Switches
- Lesson 2: Listing Catalyst 6500 Series Switch Supervisor Modules
- Lesson 3: Choosing Catalyst 6500 Series Switch Line Cards
- Lesson 4: Characterizing the packet forwarding mechanisms in a Catalyst 6500 Series Switch
- Lesson 5: Describing Unicast Packet Walks between different Line Cards
Module 2: Core Technologies on the Catalyst 6500 Series Switches
- Lesson 1: Applying the Virtual Switching System 1440 to a network M2L1 Objective: Apply the VSS 1440 system virtualization technology, capabilities, M2Lab 2-1Lab Title: Deploy and examine the VSS 1440 operation
- Lesson 2: Analyzing Multicast on the Catalyst 6500
- Lesson 3: Characterizing Identity and Authentication
- Lesson 4: Introducing Network Virtualization
- Lesson 5: Describing Data Center Interconnect Module 2
- Lesson 6: Planning and Implementing High Availability
Module 3: Catalyst 6500 Monitoring and Operations
- Lesson 1: Configuring SPAN, RSPAN and ERSPAN
- Lesson 2: Configuring NetFlow M1Lab 3-1 Lab Title: NetFlow Configuration
- Lesson 3: Introducing to Enhanced Manageability M3Lab 3-2 Lab Title: Configure EEM, GOLD and SCH
- Lesson 4: Deploying Control Plane Protection M3Lab 3-3 Lab Title: CoPP Configuration
- Lesson 5: Implementing ACL Features M3Lab 3-4 Lab Title: Access Control Lists Configuration
- Lesson 6: Prioritizing Traffic through the Catalyst 6500 using QOS
- Lesson 7: Describing Catalyst 6500 Best Practices
Target Audience
- Channel Partner / Reseller
- Customer
- Employee
Pre-Requisites
- Intermediate level knowledge and experience of deploying modular Catalyst switch products.